Pursuit F2 Help – Starting Location Group

Each form that requires a location contains one Location group. The fields within the group are shown in the figure below. The primary way to populate the location group is to use the TraCS Location Tool (TLT). If TLT can’t be used, type Override in the Map field. This will enable all the location group fields thus allowing manual entry of information.

The best method for completing the location group is to use the TraCS Location Tool (TLT). When in the Map field, click the Locate button in the upper right to start the TLT. When the location of the incident has been properly located with the TLT, all of the required fields of the Location Group will be completed. Though, if applicable, the Structure information fields will need to be filled in. See the document below for more information on how to use the TLT to set a location

TraCS Location Tool (TLT)

Out of State

Select whether your agency’s participation in the active vehicle pursuit began within or outside of the State of Wisconsin.

Out of State Starting Location

Enter a description of the location outside of the State of Wisconsin where the participation by your agency in the active vehicle pursuit began.

Map

DMV County

DMV Municipality

On Highway Type

On Highway Number

On Highway Dir

On Street Name

Estimated Distance From Intersection

Direction From Intersection

From At Highway Type

From At Highway Number

From At Highway Dir

From At Street Name

Structure Type

Structure Number

Mapping program fields

Latitude

Longitude

X Coordinate

Y Coordinate

Municipality Township Type

On Roadway ID Number

On Roadway Link Offset

Override

TraCS Guides