This group is visible for all inspection levels except
- Level 2 (Walk around Driver/Vehicle)
...
- Level 3 Driver only.
...
- Level 4 Special Inspection
...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Enabled Fields
- Fields enable based upon the number of Axels in the summary group.
...
- All fields use the Break Measurement databar
| Info |
|---|
The Brake Measurement Advanced databar is used by a field to collect brake measurements on a commercial motor vehicle. Its interface for selecting chamber types and measurements is the only difference from the original Brake Measurement databar. The Brake button launches the Brake Measurement editor, which allows the user to select the chamber type being inspected and then either indicate the brake measurements in inches or identify them as inoperative or not measurable. The Brake Measurement editor is shown below. Basic Mode - Allows you to launch the Break Measurement editor and displays the selection in the databar once a selection has been made. Basic mode is a compact version of advanced mode that provides the same functionality. Advanced Mode - Allows you to launch the Break Measurement editor and displays the selection in the databar once a selection has been made. |
Axel Chamber
- If blank will delete any value on the Left and Right Side Measurements.
Left/Right Side Measurement
- if the measurements are off then the field turns red.
...
...
